SPECIFIKACIJE:
-
The INOmini 661 is a sensitive, DSP-based (SDR) receiver for EBU Band III DAB and DAB+ digital radio broadcasts.
-
Easy front-panel setup uses jog-wheel menu navigation.
-
A large LCD display shows essential signal parameters, demodulated audio levels, alarm conditions and program related metadata. Critical system menus are hidden.
-
Balanced analog and AES-digital program line outputs are available simultaneously; levels are independently adjustable.
-
Flashing-red front-panel alarms and rear-panel ‘tallies’ indicate DAB Loss, Low Signal and Audio Loss.
-
All receiver setup parameters are held in non-volatile memory.
-
When issued, free firmware updates are easily installed in the field.
Tuning Range
DAB Band III, Mode 1 (174.928MHz – 239.200MHz); all EBUsanctioned frequency allocations (Blocks 5-12, A-D) plus Block 13 A-F
75-ohm (BNC)
Sensitivity
10dBμV for error-free reception
Audio Codecs
MPEG-1, Audio Layer 2 (MP2); HE-AAC (AAC+)
Audio Response
±0.25dB, 20Hz – 20kHz
Signal Parameters Displayed
FQ (FIC Quality), RF (RSSI), SNR, CNR
Ensemble Label, Component List & ID, Service List & ID, Dynamic Label, PTY, Sample Rate, Bit Rate, Gain Mode, Service Mode, Protection Info, Current CU & Address, Country, Language, Time & Date
Program Audio Outputs
-
Balanced Analog (XLR) Left and Right outputs are adjustable from –15dBu to +15dBu in 0.2dB steps.
-
AES Digital (XLR) output at 44.1kHz is adjustable from –30dBFS to 0dBFS in 0.2dB steps.
-
Headphone Jack (3.5mm TRS) has adjustable listening level.
Front-Panel Red-Flashing Alarms
-
DAB Loss: Fixed metrics determine loss of digital radio reception.
-
Low Signal: Alarm and reset trigger levels are independently adjustable relative to the RF signal level display.
-
Audio Loss: Alarm threshold is adjustable between 0dB and –40dB, and the alarm delay interval is adjustable between OFF and 120 seconds.
-
Alarm “Tallies”: Individual open-collector NPN transistor outputs to ground are programmable for logic polarity.
USB Port
The front-panel mini-USB port allows the quick uploading of firmware updates when issued.
Power Requirement
12VDC at 335mA; a universal 90 - 240 VAC inline switching power supply is included with the INOmini 661 receiver.
Mounting Options
An optional rack adapter accepts up to three INOmini modules in a 1U, 19-inch rack space. The 661 also may easily be fastened to any convenient surface with two small screws.
Size and Weight
4.6cm H x 14cm W x 14cm D; 1.8kg shipping weight
Environmental
Continuous operation at ambient temperatures between 32ºF/0ºC and 122ºF/50ºC; 0-95% relative humidity, non-condensing, altitudes to 10,000ft/3,048m.